ER-X series ionizers were conceived with wide surface areas in mind. To achieve optimal charge removal of surfaces, various concepts were considered. Besides operation using variable air pressure (from airless to 5 bar air pressure), discharge frequency and ion balance can be set manually. Naturally the ionizers can also be operated in automatic mode.
Other advantages include four different head sizes, from 160mm to 640mm in length, and the ability to connect up to two heads to one controller. Hence areas up to 1.2m wide can be handled. The heads feature an angle adjustment of 360° permitting the best possible charge neutralization.
Manual mode (discharge frequency and ion balance)
Up to two heads can be connected to one controller
Replacement discharge needle unit
High / low temperature resistant head *)
Wide area ionizer
Effective charge removal width
Max. +/- 30V
Filtered air, max. 5bar
*) The ER-X□HC high / low temperature resistant head can be used in a temperature range from -60°C to +200°C. Use this head in combination with the new controller ER-XC02 (produced from April 2016 onwards).
Max. no. of connectable heads
Power supply voltage
24V DC +/- 10%
Display status for heads 1 and 2 (operation status, check, error, ion generation monitor and charge level monitor)
PhotoMOS, max. 100mA (check and error)
Activate/deactivate discharging needles
Neutralization of foil during production processes
Removal of static electricity from IC components in trays
Neutralization of small electronic components (without compressed air)